D10 Super Bright Diving Flashlight 3 Color Underwater 100m Photography COB Light Rating IPX8 Highest Waterproof Diving Light
describe:
1. Material: The shell is made of aviation-grade aluminum alloy, which is wear-resistant and anti-drop.
2. Lamp cup: adopt glass lens design, strong penetrating power, good lamp bead condensing effect, higher brightness.
3. Process: The surface adopts three-level hard anodizing process to prevent rust and corrosion.
4. Lock: When you receive the flashlight, you need to press the two switch buttons at the same time to unlock it, and press the two switches at the same time to enter the lock mode to prevent accidentally turning on the flashlight.
5. Bracket: The hole design of the camera bracket can use a handle bracket or a spherical bracket, which is very convenient to use.
6. Waterproof: All the connections of the product adopt pressure rubber ring, so that the rubber ring and the flashlight are in close contact. The apron bears more pressure and has better waterproof effect. In our most in-depth tests, the waterproof level has reached the PX8 waterproof level, and the flashlight can work normally under 100M water (please tighten the charging hole screws before diving to prevent water ingress).
7. Type C charging: Unscrew the screw, you can use the 5V mobile phone charger to charge the flashlight. During the charging process, the switch indicator light will turn red, and when the battery is fully charged, the switch indicator light will turn blue.
8. Switch indicator:
(1) When the battery power is low, the indicator light is red; when the battery power is high, the flashlight is blue.
(2) When the battery power is low, the indicator light will flash for 10 seconds and then go out.
9. Temperature control protection: When the temperature of the flashlight is higher than 50 degrees Celsius, the flashlight will automatically reduce the brightness by 50%-30%.
Note: If the temperature of the flashlight drops to 40 degrees Celsius, the brightness of the flashlight will return to 100%. If the flashlight is used underwater, the temperature of the flashlight will be lower than 40 degrees Celsius. Therefore, it is recommended that you use a flashlight underwater.
10. Applicable to: various underwater activities, such as snorkeling, picking, fishing, wild fish fishing, etc.
Specification:
Name: 3-color diving flashlight COB diving light for underwater 100m photography
Colour: Black
Light color: white light/red light/blue light
Voltage: 3.7V
Lumens: 18000LM
Color rendering index: Ra95
The bulb types are as follows:
White light: COB (5000-6500K)
Red light: LED (620nm)
Blue light: LED (455nm)
Charging method: Type-C charging
Use battery: 3*21700 power battery
Battery capacity: 14400 mAh
Working hours are as follows:
5000 lumens: 240 minutes of continuous work
9000 lumens: can work continuously for 180 minutes
18000 lumens: can work continuously for 90 minutes
(Note: The test results have deviations, please refer to the actual situation.)
The 2 switch light modes are as follows:
Switch 1: 4 modes adjustable (red light always on/red light flashing/blue light always on/double-click switch: red and blue flashing)
Switch 2: 3 modes adjustable (white light strong light: 18000lm/ white light medium light: 9000lm/ white light low light: 5000lm)
Beam angle: 140°
Switch type: push button switch
Waterproof depth: below 100 meters
Waterproof rating: IPX8
Maximum range: 300-500m
Size: 132*60*60mm
Net weight: 605g (without handle weight)
Packing type: 1*flashlight, 1*ball holder, 1*handle holder, 1*charging cable, 1*wrench,2*screw
Tips:
1. The flashlight has a special structure and uses special tools for installation. Disassembling by yourself may cause damage to the flashlight.
2. Before each dive, please carefully check whether the waterproof position of the flashlight is tight, if it is loose, please tighten it before use.
3. After each dive, please rinse the thread and surface of the flashlight interface and switch with clean water. When the switch is slightly stuck, it can be cleaned with detergent. After the flashlight is dry, you need to reapply waterproof lubricant on the flashlight thread interface.